Page 4 of 4 FirstFirst ... 234
Results 31 to 33 of 33

Thread: NTool releases and news

  1. #31
    Administrator
    Join Date
    Feb 2010
    Posts
    18,880

    Default

    Nokia Tool v0.056

    Code:
    - support for Android 10 added for ANT ( SERVICE FUNCTION NOT SUPPORTED )

  2. #32
    Administrator
    Join Date
    Feb 2010
    Posts
    18,880

    Default

    Nokia Tool v0.058

    Code:
    - support for Android 10 added for Nokia 3.1 ( SERVICE FUNCTION NOT SUPPORTED, DOWNGRADE TO FW 3.220 )
    - support for Android 10 added for Nokia 5.1 ( SERVICE FUNCTION NOT SUPPORTED, DOWNGRADE TO FW 3.220 )

  3. The Following 2 Users Say Thank You to the_laser For This Useful Post:


  4. #33
    Administrator
    Join Date
    Feb 2010
    Posts
    18,880

    Default

    Nokia Tool v0.059

    Code:
    - added initial support for UNISOCK-based Nokia phones : firmware flashing, usercode read, factory reset
    - supported models : Nokia 105, Nokia 110, Nokia 215, Nokia 220, Nokia 225, Nokia 3310 3G
    Code:
    for Identify, Service functions of Nokia 3310 3G phone, you must create special diagnostic cable.
    it is very simple - get usual USB cable and cut PIN 1 (VBUS/VCC) line ( usually red line )
    Code:
    Important note for UNISOCK drivers :
    
    Before drivers install : 
    
    1.
    i'm strongly recommend to uninstall all and any existing UNISOCK drivers on system :
    
    for this you can run, according to your system, either Drivers\FP_Drivers\DriverUninstall64.exe or Drivers\FP_Drivers\DriverUninstall32.exe ( as Administrator )
    I'm not sure that it will uninstall older or modified unisock drivers, so to cleanup system completely, get RAPR, 
    run it as Administrator and delete all Ports ( COM & LPT )  drivers with manufacturers "Spreadtrum","TNS", "UNISOC" ( check "Force deletion" )
    
    2.
    Nokia 3310 3G driver signed with expired certificate, so in order to install FP_Drivers_Zouk, you must restart PC with driver signature enforcement DISABLED.
    
    How to  ( for recent windows versions ) :
    
    settings -> update and security -> recovery -> Advanced startup
    after restart select "disable driver signature enforcements"
    
    For windows 7 just press F8 during startup, then go to “Advanced Boot Options”.
    and select  “Disable Driver Signature Enforcements”
    
    Only after this you can proceed with drivers installation.
    Take note that signature enforcements only disabled until next reboot.
    
    
    After you restared with disabled signature enforcements, proceed with drivers installation : 
    
    There are 3 UNISOCK drivers folders :
    
    Drivers\FP_Drivers
    Drivers\FP_Drivers_Zouk
    
    inside these folders, just run setup DriverSetup.exe ( as Administrator ). 
    If asked, press "Install driver anyway".
    
    Drivers\FP_Drivers_Queen
    
    inside this folder, if you have 64-bit windows, go to amd64 and run dpinst.exe ( as Administrator )
    if you have 32-bit windows, go to x86 and run dpinst.exe ( as Administrator )
    If asked, press "Install driver anyway"

  5. The Following User Says Thank You to the_laser For This Useful Post:


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •