Page 4 of 4 FirstFirst ... 234
Results 31 to 35 of 35

Thread: NTool releases and news

  1. #31
    Administrator
    Join Date
    Feb 2010
    Posts
    18,862

    Default

    Nokia Tool v0.056

    Code:
    - support for Android 10 added for ANT ( SERVICE FUNCTION NOT SUPPORTED )

  2. #32
    Administrator
    Join Date
    Feb 2010
    Posts
    18,862

    Default

    Nokia Tool v0.058

    Code:
    - support for Android 10 added for Nokia 3.1 ( SERVICE FUNCTION NOT SUPPORTED, DOWNGRADE TO FW 3.220 )
    - support for Android 10 added for Nokia 5.1 ( SERVICE FUNCTION NOT SUPPORTED, DOWNGRADE TO FW 3.220 )

  3. The Following 2 Users Say Thank You to the_laser For This Useful Post:


  4. #33
    Administrator
    Join Date
    Feb 2010
    Posts
    18,862

    Default

    Nokia Tool v0.059

    Code:
    - added initial support for UNISOC-based Nokia phones : firmware flashing, usercode read, factory reset
    - supported models : Nokia 105, Nokia 110, Nokia 215, Nokia 220, Nokia 225, Nokia 3310 3G
    Code:
    for Identify, Service functions of Nokia 3310 3G phone, you must create special diagnostic cable.
    it is very simple - get usual USB cable and cut PIN 1 (VBUS/VCC) line ( usually red line )
    Code:
    Important note for UNISOC drivers :
    
    Before drivers install : 
    
    1.
    i'm strongly recommend to uninstall all and any existing UNISOC drivers on system :
    
    for this you can run, according to your system, either Drivers\FP_Drivers\DriverUninstall64.exe or Drivers\FP_Drivers\DriverUninstall32.exe ( as Administrator )
    I'm not sure that it will uninstall older or modified UNISOC drivers, so to cleanup system completely, get RAPR, 
    run it as Administrator and delete all Ports ( COM & LPT )  drivers with manufacturers "Spreadtrum","TNS", "UNISOC" ( check "Force deletion" )
    
    2.
    Nokia 3310 3G driver signed with expired certificate, so in order to install FP_Drivers_Zouk, you must restart PC with driver signature enforcement DISABLED.
    
    How to  ( for recent windows versions ) :
    
    settings -> update and security -> recovery -> Advanced startup
    after restart select "disable driver signature enforcements"
    
    For windows 7 just press F8 during startup, then go to “Advanced Boot Options”.
    and select  “Disable Driver Signature Enforcements”
    
    Only after this you can proceed with drivers installation.
    Take note that signature enforcements only disabled until next reboot.
    
    
    After you restarted with disabled signature enforcements, proceed with drivers installation : 
    
    There are 3 UNISOC drivers folders :
    
    Drivers\FP_Drivers
    Drivers\FP_Drivers_Zouk
    
    inside these folders, just run setup DriverSetup.exe ( as Administrator ). 
    If asked, press "Install driver anyway".
    
    Drivers\FP_Drivers_Queen
    
    inside this folder, if you have 64-bit windows, go to amd64 and run dpinst.exe ( as Administrator )
    if you have 32-bit windows, go to x86 and run dpinst.exe ( as Administrator )
    If asked, press "Install driver anyway"

  5. The Following 2 Users Say Thank You to the_laser For This Useful Post:


  6. #34
    Administrator
    Join Date
    Feb 2010
    Posts
    18,862

    Default

    Nokia Tool v0.060

    Code:
    - added support for service functions and network unlock of UNISOC-based Nokia phones
    - supported models : Nokia 105, Nokia 110, Nokia 215, Nokia 220, Nokia 225, Nokia 3310 3G
    Code:
    Warning !
    To use service functions for Nokia 105, Nokia 110 phones, you MUST flash firmware from our support area,
    otherwise phone will be in tampered state, until you write original IMEIs
    Code:
    Service function cost : 5 credits
    Network Unlock cost  : 5 credits
    
    Warning ! Credits charged EACH time.
    Code:
    for Identify, Service functions of Nokia 3310 3G phone, you must create special diagnostic cable.
    it is very simple - get usual USB cable and cut PIN 1 (VBUS/VCC) line ( usually red line )
    Code:
    Important note for UNISOC drivers :
    
    Before drivers install : 
    
    1.
    i'm strongly recommend to uninstall all and any existing UNISOC drivers on system :
    
    for this you can run, according to your system, either Drivers\FP_Drivers\DriverUninstall64.exe or Drivers\FP_Drivers\DriverUninstall32.exe ( as Administrator )
    I'm not sure that it will uninstall older or modified UNISOC drivers, so to cleanup system completely, get RAPR, 
    run it as Administrator and delete all Ports ( COM & LPT )  drivers with manufacturers "Spreadtrum","TNS", "UNISOC" ( check "Force deletion" )
    
    2.
    Nokia 3310 3G driver signed with expired certificate, so in order to install FP_Drivers_Zouk, you must restart PC with driver signature enforcement DISABLED.
    
    How to  ( for recent windows versions ) :
    
    settings -> update and security -> recovery -> Advanced startup
    after restart select "disable driver signature enforcements"
    
    For windows 7 just press F8 during startup, then go to “Advanced Boot Options”.
    and select  “Disable Driver Signature Enforcements”
    
    Only after this you can proceed with drivers installation.
    Take note that signature enforcements only disabled until next reboot.
    
    
    After you restarted with disabled signature enforcements, proceed with drivers installation : 
    
    There are 3 UNISOC drivers folders :
    
    Drivers\FP_Drivers
    Drivers\FP_Drivers_Zouk
    
    inside these folders, just run setup DriverSetup.exe ( as Administrator ). 
    If asked, press "Install driver anyway".
    
    Drivers\FP_Drivers_Queen
    
    inside this folder, if you have 64-bit windows, go to amd64 and run dpinst.exe ( as Administrator )
    if you have 32-bit windows, go to x86 and run dpinst.exe ( as Administrator )
    If asked, press "Install driver anyway"

  7. The Following 2 Users Say Thank You to the_laser For This Useful Post:


  8. #35
    Administrator
    Join Date
    Feb 2010
    Posts
    18,862

    Default

    Nokia Tool v0.061

    Code:
    - added support for flashing, service functions, network unlock of UNISOC-based Nokia phones
    - new supported models : Nokia 105 4G, Nokia 110 4G
    - added support for service functions of Nokia 1+ with Android 10, Android 11 firmwares

    Code:
    Notice !!!
    
    if phone have Android 10 ( ANT-2xxx ), Android 11 ( ANT-3xxx ) firmware
    then you can not use SERVICE function directly due to FIH programmers bug.
    
    Instead, you must flash special firmware ANT-214F-0UWW-B01.NBx and then
    you can use SERVICE function.
    
    After using SERVICE functions you can use any firmware you want.

  9. The Following 2 Users Say Thank You to the_laser For This Useful Post:


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •