Results 1 to 10 of 14

Thread: HOW TO WORK WITH SEMC PDA PHONES

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-19-2012, 07:32 AM #12
    the_laser
    the_laser is offline
    Administrator
    Join Date
    Feb 2010
    Posts
    18,862

    Default

    q:
    i'm trying to unlock msm8x55-based phone, i'm sure that procedure done properly, but i'm always receive error:

    Code:
    SIGNED MODE (USING SERVER)
ALTERNATIVE SECURITY BYPASS ENABLED
CFG:110000000000
 
DETACH USB CABLE FROM PHONE
REMOVE BATTERY FROM PHONE
ATTACH TESTPOINT
PRESS "READY", THEN ATTACH USB CABLE TO PHONE
 
will use DLOAD protocol ... 
0806010100900000
0D1450424C5F446F776E6C6F6164657256455231
030006
030006
030006
PROCESSING ...
REMOVE TESTPOINT NOW, THEN PRESS "READY"
 
qcReceivePacket: can't get packet start
IF TESTPOINT DONE OK,THIS IS NOT SUPPORTED MCU REVISION
CAN'T LOAD IDENTIFICATION LOADER
    a:

    bad luck, that is mcu with fixed security flaw and you can not unlock,repair trim area, repair semcboot, rebuild hwconfig using altbypass method.
    Reply With Quote Reply With Quote

  2. The Following 37 Users Say Thank You to the_laser For This Useful Post:

    bigboy85, cilian, Dayline668, DB2020, DemiMontana, Denva, digs1025, dimetri, DR_MOOSAVI, Ghano500, gm3group, gsmhelpbd, Guest™, Jupz83, Lancer93, maghsoud, maremestera, minotaur, myrwok, nomy7, Rhyan, Seeker101, sobaro, soil2020, sravan, xXx, yjese
« Previous Thread | Next Thread »

Similar Threads

  1. HOW TO WORK WITH A2-BASED PHONES
    By the_laser in forum F.A.Q.
    Replies: 6
    Last Post: 04-27-2012, 05:11 PM
  2. HOW TO WORK WITH SEMC ODM PHONES
    By the_laser in forum F.A.Q.
    Replies: 7
    Last Post: 03-25-2011, 05:03 PM
  3. HOW TO WORK WITH A1-BASED PHONES
    By the_laser in forum F.A.Q.
    Replies: 5
    Last Post: 02-06-2010, 09:04 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules