-
If you are experiencing cable issues, it might help lowering the latency.
Standard symptom: "llbug: can't get all data, got:0 expected:***"
This is done through "Device Manager" (Right-click "My Computer"->"Properties"->"Ports(COM & LPT)". Check the attachments.
Set the latency to "1" and try servicing a phone. Increase the value (once per procedure) until errors start apperaring, then set the previous value.
Example:
Latency 1,2,3,4,5,6,7 goes OK, but then
8 - "llbug: can't get all data, got:0 expected:***"
Set the value to seven or six (to be sure).
if you experiencing same "llbug: can't get all data, got:0 expected:***" using UFS as interface
then you can do one of following (or all)
1. lower speed to 115200
2. use normal SHIELDED USB2.0 cable. it must be SHORT (no more than 30 cm)
3. try to connect UFS into different USB controller on motherboard
4. try to connect UFS into EXTERNAL POWERED USB HUB
Attached Thumbnails
-
The Following 6 Users Say Thank You to GSM™ For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks