FLASHING OF DB2000,DB2010 PHONES
common for all CID:
1. go to semc tab, select proper model
2. add to firmware area correct MAIN, FS IMAGE parts of firmware. order not important.
3. select in misc. field needed CUSTPACK (.zip archive with customization files)
4. if you do not have CUSTPACK, you MUST check on settings "customize phone after flash"
5. please read notes below
6. set other settings according your needs.
7. back to semc tab, press flash.
CID 17,24,41,42,54
unsigned mode
3. skip
4. skip
5. on settings, uncheck signed mode, alternative security bypass, preloader security bypass,customize phone after flash.
for BROWN CID 41,42,73 you must disassemble phone and do testpoint operation.
testpoint is simple GND wire attached to specific points on phone board.
(upload testpoint pictures)
in that case, step 5 will be:
5. on settings, check only "use tespoint (gnd method)"
you can use special 'dual" usb+serial cable in order to significantly increase flashing speed for such phones.
you can not use script for such phones.
CID 16,29,36,37,49
signed mode
5. check signed mode
unsigned mode
5. on settings, uncheck "signed mode", "alternative security bypass"
you can only use USB as interface for phones with CID 49, some CID 36 phones can be upgraded to CID 49 via writing of corresponding EROM.
restoration files required for phones with CID 49
CID 50,51,52,53
signed mode
5. check signed mode
standalone altbypass mode
5. check "signed mode", "use alternative security bypass"
restoration files required
bypass package required
please read FAQ post about alternative security bypass.
that is preferred mode if you want to do some additional operations during flashing process.
starting from v1.1280 this method do not require restoration and bypass package files.
however, you can not use USB as interface in this method anymore
please note, that if you put in misc. edit any file, which is NOT custpack archive, it will be treated as script command file.
Reply With Quote
Bookmarks